login   |    register
Яusso-Soviэt Forum
Russian or Soviet vehicles/armor modeling forum. Hosted by Nick Cortese.
GAZ Tiger 1:35 Meng
MakiWawa
Visit this Community
Warszawa, Poland
Member Since: December 17, 2014
entire network: 293 Posts
KitMaker Network: 0 Posts
Posted: Friday, September 07, 2018 - 12:11 AM UTC
A new project
.

























Maki
Staff MemberSenior Editor
ARMORAMA
Visit this Community
Croatia Hrvatska
Member Since: February 13, 2002
entire network: 5,281 Posts
KitMaker Network: 500 Posts
Posted: Friday, September 07, 2018 - 02:45 AM UTC
Looks good. I think that one but from Xact will be my next project as well...

Why not DEF resin wheels?

Mario
canismalus
#465
Visit this Community
Nordrhein-Westfalen, Germany
Member Since: September 12, 2014
entire network: 268 Posts
KitMaker Network: 2 Posts
Posted: Sunday, September 09, 2018 - 12:39 AM UTC
Hi Piotr,

I have this one, too - It’s been sitting on the shelf of shame for a while, about as far along as yours - maybe your bulid will give me the inspiration I need to continue....good job so far in any case.

I very much agree with Mario‘s recommendation - resin wheels from DEF Models or Miniarm, though expensive, really look a lot better - not only do they have a weighted appearance, they don‘t have that awful gap between the tire and the wheel rim, as is evident in some of your photos, unfortunately.

Jerry
MakiWawa
Visit this Community
Warszawa, Poland
Member Since: December 17, 2014
entire network: 293 Posts
KitMaker Network: 0 Posts
Posted: Monday, September 10, 2018 - 04:51 AM UTC
Guys,
I am investing exclusively in models humvee, because it is my main subject matter. Remaining model, it caprice without additions.
MassimoTessitori
Visit this Community
Italy
Member Since: March 14, 2013
entire network: 195 Posts
KitMaker Network: 0 Posts
Posted: Friday, September 14, 2018 - 07:28 AM UTC
I usually utilize the hollow tyres of the kits, but I have a method to avoid that they collapse inwards:
I cut a long stripe of cardboard with the exact internal width of the tyre, I wrap it for two or three loops creating a sort of ring slightly wider than the wheel hub, I fix it with tape and insert it inside the tyre.
Then the hub, usually divided in two disks, is mounted with the tyre.
So the sides of the tyre can't collapse inside because the ring of cardboard keeps the inside space.