Excellent. Thank you PanzerArt. Now I don't have to use the Academy 113 wheels on my Lance SPL.

It may be just as cheap to buy some Acad. M113s at shows for the wheels plus the extras for the spares box (if the Acad. wheels are as good)

AFAIK, they're just clones of the Tamiya ones... H.P.

This is not a copy of Tamiya. Our wheel was designed in 3D based on wheel documentation. The wheel of Tamiya is very old, simplistic and has bad dimensions

I was talking about the ACADEMY ones.... H.P.

I just received the PanzerArt M113 wheels today and they look great! Easily WAY better than any earlier M113 family kit wheels out there, maybe with exception of new AFV Club kit. Details are excellent and in scale, casting clean and molding blocks small and easy to remove. There are two minor "issues". One is actually a result of very accurate dimensions - the outer and inner wheels are so close that guide horns of some older tracks may not fit without thinning them or adding thin distance rings between wheels. The other issue is a small inaccuracy in PanzerArt wheels - in real wheels the rivets are on a small "bulge". It is represented - and actually slightly overdone - in the new AFV Club kit, but missing in PanzerArt wheels. But compared to all other kit wheels, the PanzerArt's are huge improvement. Also the rivets and wear ring are not represented on the rear side of the wheels, but considering how close the wheels are, those details would not be visible anyway, so it's not a problem at all in my opinion. This photo from PrimePortal shows the "bulge" under rivets: Oups, I just noticed another issue in PanzerArt wheels - there are correct 8 bolts on the outer wheel, but 10 bolts on the inner wheel! To be honest, I don't care

Actually the rivets are on a flat between concave and convex toroidal sections. I think the PanzerArt may look off because they are not undercut. KL

Yes, but it creates the illusion of the "bulge", or additional convex ring. They are undercut, but the undercut profile is not as deep as it should be to be 100% accurate. I'm not sure if fully correct undercut would be achievable for one piece resin part. I doubt the silicon mold would survive removal of the part. I guess that's why PanzerArt made it shallower than it should be. But it is certainly there.

Would love to see the AMX 13 wheels in flesh. I don't trust CAD drawings. The weld beads do not look right to me.